建筑隔墻用輕質條板與其它墻體材料性能對比:
新型墻板機,具有隔音效果好、耐火、耐磨、抗滑、綠色環保等優勢,與普通紅磚相比,降低建筑物自重15%-20%,工效可提高5倍,節約施工成本,降低工程綜合造價費用約20%-25%,并且增加室內使用面積10%左右,達到建筑節能65%的標準要求,便于墻板機后期的墻體改造,且安裝房屋 無苯醛氣體釋放,被行業譽為“綠色環保墻材”。
(1)、尺寸誤差(mm):長度±5,寬度±2;厚度±1。
(2)板面平整度:長度2m,翹曲:≤2mm。
(3)掉角:板面不得有大于20×30mm掉角兩處。
(4)裂紋:板面不得產生任何有危害性的裂縫。
(5)隔板墻的限制高度:厚度為90mm、120mm、以3200mm以下為宜,在特殊條件下,可以增加高度,但墻板機從構造上要另行處理。
(6)各種異型板可以按圖紙設計加工。
我公司專業生產銷售墻板機、鋼棉機 本文由www.basiloglue.com提供
Building partition wall with light board performance compared with other wall materials:
New wallboard, has the good sound insulation effect, refractory, wear-resisting, resistance, green environmental protection advantages, compared with common red brick, reduce the weight of 15% 20%, building five times can improve the work efficiency, saving construction cost, reduce the cost of engineering cost about 20% 25%, and increase the indoor use area about 10%, to 65% of building energy efficiency standard requirements, to facilitate the late wall modification, and install housing no benzene formaldehyde gas release, known by industry as the "green wall materials".
(1), size error (mm) : + / - 5 length, width + 2; The thickness of + / - 1.
(2) the surface roughness, length is 2 m, warping, 2 mm or less.
Drop Angle (3) : panel shall not be more than 20 x 30 mm off Angle in two places.
(4) crack: panel shall not produce any harmful cracks.
(5) the limit height of the diaphragm wall: thickness is 90 mm, 120 mm, 120 mm below the advisable, under the special condition, can increase the height, but from the structure should be handled separately.
(6) all kinds of special shape plates can be designed according to the drawing.